Malco FSPC Standing Seam Panel Cutter - Drill-Powered Metal Roofing Panel Slitter

The Malco FSPC Standing Seam Panel Cutter provides a fast, precise way to rip standing seam metal roofing panels while producing a clean edge on both sides of the cut. Unlike cutting methods that leave a scrap side, the FSPC uses smooth slitting wheels so both sections of the panel can remain usable.

Designed for standing seam panels with ribs 1" or taller, the FSPC features polymer drive wheels that advance the tool through the panel while helping protect painted finishes. An adjustable fence indexes directly from either panel rib, with interchangeable 8" and 16" rails for straight, repeatable cuts without the need to snap a chalk line. The cutter can also be used without the fence for ripping flat sections of R-panel and similar profiles.

Powered by a compatible lithium-ion cordless drill, the FSPC can cut at speeds up to 75 feet per minute. Replaceable cutting discs and drive wheels help extend the life of the tool, and the complete system is supplied in an IP67-rated hard case for protection during transport and storage.

Key Features

• Fast Cutting: Rip cuts panels at speeds up to 75 ft./min.
• Clean Cut on Both Sides: Smooth slitting wheels leave clean edges so both halves of the panel remain usable.
• Adjustable Fence: Indexes from either panel rib for straight, repeatable cuts without snapping a chalk line.
• 8" & 16" Fence Rails: Interchangeable rails accommodate different cut widths.
• Finish-Friendly Drive Wheels: Polymer wheels advance the cutter while helping protect painted panel finishes.
• Cuts From Either Side: Allows the tool to be positioned from either side of the panel for greater flexibility.
• Replaceable Wear Components: Cutting discs and drive wheels can be replaced to extend tool service life.
• IP67-Rated Hard Case: Protects the cutter and components during transport and storage.

Material Capacity

• Painted steel: up to 24 gauge
• Stainless steel: up to 26 gauge
• Copper: up to .032"
• Zinc: up to .032"
• Aluminum: up to .032"

Panel Compatibility

• Designed for rip cutting standing seam roofing panels with seams 1" or taller
• Adjustable fence indexes from either panel rib
• Can be used without the fence for ripping flat sections of R-panel and similar profiles
• Not intended for cutting across corrugated panels or profiles with peaks and valleys

Drill Requirements

• Lithium-ion cordless drill
• Minimum torque: 45 ft-lb
• Maximum operating speed: 500 RPM
• Use the drill's lowest speed setting for maximum control and torque
• Do not exceed 500 RPM